Go Board Glue-up Tool Plans electric nylon guitar plans

Go Board Glue-up Tool Plans electric nylon guitar plansOverview Specs Plan Info General Information I was tired of using dozens of clamps to glue braces and reinforcement plates to my instrument tops and backs. I designed and built this Go Board to quickly and accurately handle this luthier task. The Go Board is adjustable and uses fiberglas rods used in tent construction. The rods act as pressure clamps with vinyl protection ends on them. The floor of the jig can be adjusted so you can vary the distance

It uses a double-locking design the was revolutionary at the time and has been listed as one of the "Top 10 Most Earth Shaking Guitar Innovations"

pot holes etc

Lower Bout: 223mm (8

Solid Body Electric Guitar #4 Fretboard:

Peghead Type: Standard L-5 Type

Finally a file is included for the Head and Tail Blocks

Ideal for Flatpicking & Fingerpicking

and traditional surface mounted

5" (38mm) diameter tube in lieu of the typical 3" aluminum tube used for acoustic guitars

Body Length: 463

Body Maximum Length = 18

Neck Tone Control Pot