SuperPINDA Probe for Prusa i3 MK3/S, MK2.5/S and MINI Thermistor the less flexible it will

the less flexible it will become

Flashforge Guider 2S High Temperature Heatsink

Don't drain to sink directly

near isotropic shrinkage (very low CTE)

100% Made in USA

SuperPINDA Probe for Prusa i3 MK3/S, MK2.5/S and MINI Thermistor the less flexible it willSuperPINDA replaces the P. I. N. D. A. V2 (MK3 S, MK2. 5 S) and M. I. N. D. A. (MINI). When replacing the original probe with SuperPINDA make sure to use the 3. 9. 2 or higher firmware version. SuperPINDA is temperature independent, with higher quality sensor, and doesn't need a thermistor. Making the first layer calibration and mesh bed leveling much easier and consistent. Compatible printer models: MK3 S +, MK2. 5 S, MINI +