1-1/2" PVC Push Point Compression Points without removing the point

without removing the point

or If there is no bell housing then a coupling must be glued onto the pipe and the part inserted into the coupling

the push cap may be struck with a hammer to drive the pipe past the obstruction and on to the other side

The push point is connected to the front or leading end of the pipe and the push cap is inserted into the bell housing on the opposite end of the same pipe

This allows the hole to be opened from a shallow hole on the edge of the sidewalk and then travel deeper to clear the bottom of the curb and gutter and exit into the micro trench or pot hole in the road

1-1/2" PVC Push Point Compression Points without removing the pointThis part is used to insert a 1 1 2" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. It is threaded into the end of a 2 sch 40 PVC pipe or conduit. As it is screwed into the pipe it cuts its own threads on the inside of the pipe much like a tap. The outside diameter of the push point will be the same as the outside diameter of the pipe itself. Next this pipe point assembly is shoved into the same opening