1-1/4" Compression Point Compression Points Insert an allan wrench into

Insert an allan wrench into one hole untill it seats in the allan screw on the opposite side of the hole in the point

As the shafts are extracted the tape or line is pulled into the hole which can then be attached to the microduct and installed

Next this pipe/point assembly is shoved into the same opening created earlier by the Bullet Mole

The angle of penetration can also be adjusted pitch downward from 4° to 15°

It is actually 3" in diameter and will make a hole large enough to accommodate a 2" Sch 40 pipe with a coupling

1-1/4" Compression Point Compression Points Insert an allan wrench intoThe compression point is the first part to go through the ground and is attached to the shaft. It breaks rocks, splits roots and other debris as it makes its way under the pavement and opens a hole larger than the shafts. The actual diameter of this part is 2" in. It will make a hole large enough to accommodate a 1 1 4" pipe with a coupling.