1-1/4" PVC Push Point Compression Points It should be 5/8 of

It should be 5/8 of an inch long

This unique design combination allows for the female threaded end of the connector to be easily manuvered in order to quickly "FIND" the male thread of the shaft and be connected to it

This part is made of stainless steel and is used to insert a - 2" "k" or "L" wall copper pipe into the ground after the initial hole is opened with the compression point

This pull connector will make a secure and strong connection to any 1-1/2" rolled Polyethylene conduit for fiber optic - Poly pipe for water lines or -Polyethylene pipe for gas lines  Etc

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

1-1/4" PVC Push Point Compression Points It should be 5/8 ofThis part is used to insert a 1 1 4" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap. The Push Point will have the same as the outside diameter of the pipe itself. After the Push Point is attached the pipe then this assembly is shoved into the hole made by the compression point. As it proceeds, roots or